fußgängerampel

die ampel richtet sich an den autofahrer. sie ist also immer grün, bis der fußgänger auf den knopf drückt. dann wird sie kurz rot und bleibt am ende wieder bei grün stehen.

 

Advertisements

Untitled

wer sich für die ansteuerung on servos interessiert:

http://seeseekey.net/blog/tag/arduino

ein sehr nützliches tutorial mit schaltkreisen mit fritzing erstellt

http://www.arduino-tutorial.de/2010/06/page/4/

Servo

 für die hausaufgabe

Servo library

 

 

This library allows an Arduino board to control RC (hobby) servo motors. Servos have integrated gears and a shaft that can precisely controlled. Standard servos allow the shaft to be positioned at various angles, usually between 0 and 180 degrees. Continuous rotation servos allow the rotation of the shaft to be set to various speeds.

 

The Servo library supports up to 12 motors on most Arduino boards and 48 on the Arduino Mega. On boards other than the Mega, use of the library disables analogWrite() (PWM) functionality on pins 9 and 10, whether or not there is a Servo on those pins. On the Mega, up to 12 servos can be used without interfering with PWM functionality; use of 12 to 23 motors will disable PWM on pins 11 and 12.

 

Circuit

Servo motors have three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino board. The ground wire is typically black or brown and should be connected to a ground pin on the Arduino board. The signal pin is typically yellow, orange or white and should be connected to a digital pin on the Arduino board. Note servos draw considerable power, so if you need to drive more than one or two, you’ll probably need to power them from a separate supply (i.e. not the +5V pin on your Arduino). Be sure to connect the grounds of the Arduino and external power supply together.